PANS-25/32S Hand Push Spring Roller Shutter System

25-32 manual roller shutter system

The system comes with a limiter, and the roller blind automatically stops when it rises/falls to a fixed position

1. The system is equipped with a built-in balancer and spring system to achieve instant pulling and stopping of the roller blind. The roller blind can be pulled or pushed down by hand to stop at the desired position;

2. According to the square meter weight of the fabric, the width and height of the roller blind, different specifications of spring systems can be selected; According to the weight of the lower beam and the expected lifting speed, different springs can be set

Number of pre tensioned coils of the spring;

3. By adjusting the number of pre tightening turns of the spring and the weight of the lower beam, the flatness and collection effect of the fabric can be adjusted; The weight of the lower beam of a general manual pushing system is greater than that of an automatic rising spring roller blind

Lower beam weight;

4. This system does not come with a beam, and the spring can be pre tightened and self-locking. The spring can be unlocked by the buckle on the installation code, thus achieving simple installation;

5. Due to the use of a self regulating balance force balancer, this system has a wider range of applicability and simpler debugging for spring systems of the same specification; Suitable for a 2-meter high spring hand roll

Curtain, if the height exceeds 2 meters, it is inconvenient to operate